Search:

Type: Posts; User: c4c5specialist

Page 1 of 20 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    1
    Views
    57

    Hey Ken, Im going to do some digging on this. ...

    Hey Ken,

    Im going to do some digging on this. Once I get your VIN, I will focus on it and communicate further.

    Allthebest, Paul
  2. Hi there, You are most likely looking at a...

    Hi there,

    You are most likely looking at a stripped out nylon gear within the drivers side headlamp motor actuator.

    It is quite common and can usually be repaired by an aftermarket gear kit or...
  3. Replies
    5
    Views
    489

    Good morning, What other modifications do you...

    Good morning,

    What other modifications do you have under the hood? Cold air induction?? Oiled air filter????

    Is the duct between the mass air flow and the engine tight and without cracks ????...
  4. Replies
    5
    Views
    605

    HI there, My suggestion, being that you...

    HI there,

    My suggestion, being that you already know how to remove the ignition switch, I would order the lock cylinder from your local GM dealership, have them code it to your keys and then...
  5. Replies
    5
    Views
    605

    HI there, The first thing you can do is check...

    HI there,

    The first thing you can do is check your battery cables to assure there is no oxidation on the cables themselves where they contact the battery terminals. Torque the bolts to 11 ft lbs....
  6. Sticky: HI there, This IS the GM fix. Just remember...

    HI there,

    This IS the GM fix. Just remember that the battle was with DENSO, not GM.

    Engineering worked their asses off trying to get this sooner, However, per the TSB Corvette was last in...
  7. Replies
    6
    Views
    457

    HI there, Unfortunately no. I have...

    HI there,

    Unfortunately no.

    I have experienced that some do not take the uploaded file.

    I do not know why this is, however, usually an exchanged unit from an ACDelco electronics service...
  8. Replies
    6
    Views
    457

    HI there, I would recommend that you start by...

    HI there,

    I would recommend that you start by disconnecting your negative battery cable for 15 mins and reconnect it.

    Then see what happens with your radio functions.

    Please keep us posted,...
  9. Sticky: Good morning, To my knowledge, this is ONLY...

    Good morning,

    To my knowledge, this is ONLY for the clock issue, I know of nothing else that this update does.

    Now, I DO know that the latest MAP DVD available at www.gmnavdisc.com also can...
  10. Sticky: HI there, Im not sure honestly, I am using...

    HI there,

    Im not sure honestly, I am using Windows 10 PRO and do not know. I have fielded this process back to engineering, I will repost when I have an answer

    Allthebest, Paul
  11. Replies
    6
    Views
    585

    HI there, Excellent news. Allthebest, Paul

    HI there,

    Excellent news.

    Allthebest, Paul
  12. HI there, How is your AM frequency reception...

    HI there,

    How is your AM frequency reception ????

    I would say that certainly it is possible that you have an issue within the head unit and I have seen anything metallic on the radio will get...
  13. Replies
    11
    Views
    899

    HI there, We utilize Picoscope with other...

    HI there,

    We utilize Picoscope with other software aside from GM. It is an amazing tool which I use often.

    Allthebest, Paul
  14. HI there, The first place to go is the antenna...

    HI there,

    The first place to go is the antenna amplifier. This is located against the drivers side B pillar behind the plastic trim. If you move your seat all the way forward, you can then...
  15. Replies
    8
    Views
    606

    Hey Todd, I always add a drop of engine oil...

    Hey Todd,

    I always add a drop of engine oil to the tip and the socket for the pushrod to assist in assembly.

    GM recommends the following per document ID: 281433

    Rotate the crankshaft until...
  16. Sticky: HI there, YOU MUST use a CD-RW, anything else...

    HI there,

    YOU MUST use a CD-RW, anything else and it will NOT WORK!

    Allthebest, Paul
  17. Replies
    11
    Views
    899

    HI there, Welcome to you!!!! Allthebest,...

    HI there,

    Welcome to you!!!!

    Allthebest, Paul
  18. Replies
    6
    Views
    616

    HI there, Welcome to you. As far as the...

    HI there,

    Welcome to you.

    As far as the 'flickable', the increased mass/vehicle weight of the Corvette vs FRs may be part of your issue. Unfortunately, if they have the original Goodyear...
  19. Replies
    6
    Views
    585

    Hi there, There is a resistance value for,...

    Hi there,

    There is a resistance value for, this sensor. The resistance to indicate -37 should be about 240.000 ohms.

    So I would start there, but when you disconnect the sensor, make certain...
  20. HI there, An entire blank navigation screen...

    HI there,

    An entire blank navigation screen may be a different issue.

    Do you notice anything else not working when this occurs? Do you notice any other warning lights displayed when this...
  21. Replies
    1
    Views
    372

    HI Rob, I have done a lot of them. My...

    HI Rob,

    I have done a lot of them.

    My suggestion is to obtain one with high reserve capacity to assist with storage. Higher cold cranking amps means a weaker reserve capacity and inversely, a...
  22. Sticky: Very interesting, as I used the Window PRO 10...

    Very interesting, as I used the Window PRO 10 operating system.

    I do not know if that has a correlation or not.

    I will put some feelers out and repost up.

    Allthebest, Paul
  23. Sticky: HI there, Give it up to 20 mins to accept the...

    HI there,

    Give it up to 20 mins to accept the disc and do the lay out, no need to fold the door back up.

    Let us know how you make out, Paul
  24. 2020 Corvette, Motor Trend Car of the year!!!!

    https://media.chevrolet.com/media/us/en/chevrolet/home.detail.html/content/Pages/news/us/en/2019/nov/1118-corvette.html
  25. Sticky: Step 1: Battery condition and voltage checks ...

    Step 1: Battery condition and voltage checks

    The single biggest issue I have experienced with column lock issues is correct battery strength and voltage. This means a strong battery with clean...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4