Search:

Type: Posts; User: LLC5

Page 1 of 20 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    10
    Views
    343

    The stop lights run through the turn signal...

    The stop lights run through the turn signal switch or hazard switch, I haven't checked my ETM yet to be sure, but my guess is hazard switch. When the turn signal and 4 way switch were integrated...
  2. Replies
    6
    Views
    1,382

    Yeah, it's hard to tell if a fuse is good without...

    Yeah, it's hard to tell if a fuse is good without powering it up and testing it with a test light. C/LALDL I believe is supposed to refer to Courtesy Light Assembly Line Data Link, as there is fused...
  3. Replies
    6
    Views
    1,382

    You checked all the fuses (with the ignition on,...

    You checked all the fuses (with the ignition on, engine off) under the hood and under the passenger side interior firewall with a test light and all the fuses had power on both side of the fuse pins?
  4. Replies
    6
    Views
    1,382

    You should have just popped a fuse. Use a test...

    You should have just popped a fuse. Use a test light to check every fuse in both fuse boxes, it is very hard to impossible to visually see a bad fuse when removed.
  5. Replies
    2
    Views
    687

    If I understand your question correctly, no. The...

    If I understand your question correctly, no. The temp reading number on the climate control unit is controlled by the driver (left) knob, the passenger knob (right) only has colors behind it for...
  6. Replies
    6
    Views
    1,892

    Have you installed the new starter yet or just...

    Have you installed the new starter yet or just tighten the main battery cable nut? It could be your starter, but I would want to know that the battery tests good, I have found quite a few bad new...
  7. Replies
    6
    Views
    1,892

    Not possible if the connection is good clean and...

    Not possible if the connection is good clean and tight. Batteries can recover just enough voltage after sitting to start a vehicle and your description of lights flashing and codes indicates low...
  8. Replies
    6
    Views
    1,892

    I hate to say it but your #2 problem indicates a...

    I hate to say it but your #2 problem indicates a low voltage issue. Charging system voltage when hot and under a load with all accy's on should be checked (above 13.0V) and load test any brand new...
  9. Replies
    2
    Views
    749

    Is the inhibitor switch (neutral safety switch)...

    Is the inhibitor switch (neutral safety switch) plugged in correctly?
  10. The dentist sure knows what the X-rays do to us,...

    The dentist sure knows what the X-rays do to us, that's why they hide behind a screen.

    People are under the false opinion that battery vehicles are clean to the earth. Wrong! Just the opposite,...
  11. Replies
    6
    Views
    2,056

    Let me know if you have any questions.

    Let me know if you have any questions.
  12. Replies
    6
    Views
    2,056

    Ok, I checked this morning. The adjusters are...

    Ok, I checked this morning. The adjusters are inside the headlight assembly. There is a round plastic cover you can remove on the plastic surround facing the hood, but I would just remove the whole...
  13. Replies
    6
    Views
    2,056

    Take the plastic shield surrounds off the...

    Take the plastic shield surrounds off the headlight assemblies with the lights up and you should be able to see the adjusters. I believe one is facing towards the hood with a long adjuster if I...
  14. Thread: wheel balance?

    by LLC5
    Replies
    3
    Views
    1,268

    It could be a bad tire, bent wheel, or a balance...

    It could be a bad tire, bent wheel, or a balance problem. Take it back the installer and have them check it over.
  15. If the charger you are referring to is NOT a...

    If the charger you are referring to is NOT a float type charger and is indeed constantly throwing 2 amps at your battery, then yes you could damage the battery if left unattended. Never leave a...
  16. If you have the piston at TDC on the compression...

    If you have the piston at TDC on the compression stroke with no air pressure the valve can still drop down until it contacts the piston, which means that it will not fully drop into the cylinder...
  17. Maybe I missed it, but I didn't see where...

    Maybe I missed it, but I didn't see where compressed air goes into the cylinder to hold the valves up when you remove the keeper. Also make darn sure that each cylinder is on the compression stroke.
  18. Thread: Battery suppliers

    by LLC5
    Replies
    6
    Views
    1,851

    Not always true, if you leave a 2 amp charger on...

    Not always true, if you leave a 2 amp charger on a battery for multiple days you can over charge and damage the battery, which not only harms the battery but is dangerous. Never leave a non...
  19. Replies
    9
    Views
    2,351

    They both have their down sides, the Kwik Lift is...

    They both have their down sides, the Kwik Lift is bulkier and you have to park the vehicle at an angle every time you park it unless you want to jack up the rear of the vehicle every time you park or...
  20. Thread: Battery suppliers

    by LLC5
    Replies
    6
    Views
    1,851

    The born on date is stamped onto the case of the...

    The born on date is stamped onto the case of the battery, it will give the month and year it was made. Sometimes it's in a code and you have to decipher it depending on the manufacturer, but it's not...
  21. Thread: Battery suppliers

    by LLC5
    Replies
    6
    Views
    1,851

    Dealer prices will probably be higher. Make sure...

    Dealer prices will probably be higher. Make sure you check the born on date on any battery you purchase (ideally with in 1-2 months) and then have it load tested with a carbon pile load tester before...
  22. Replies
    9
    Views
    2,351

    I meant the wheels on the vehicle, you still have...

    I meant the wheels on the vehicle, you still have to jack up the vehicle after it is on the lift.
  23. Replies
    9
    Views
    2,351

    Your right I was thinking of the other lift. Just...

    Your right I was thinking of the other lift. Just saw the video on the Kwik Lift, looks like a lot of work to get a vehicle in the air, especially if the wheels need to come off. I do like the...
  24. Replies
    9
    Views
    2,351

    I have not used one, but by just looking at it...

    I have not used one, but by just looking at it and seeing it in operation, it looks like more work than it is worth. I don't think you can drive over it, you have to move and store it each time it is...
  25. I might take a slight exception to the moisture...

    I might take a slight exception to the moisture aspect, 3/4 tank of oxygen (or about) with extreme temperature changes will create a certain amount of condensation, fully sealed tanks do help with...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4