Activity Stream

Good luck buying any 2020 or 2021 model for MSRP. The dealer double bump should be record breaking.

Pricing for 2021 models will be slightly higher for base.

The following is from page 6-45 of the 2003 Corvette service manual: NEW FLYWHEEL, CLUTCH, AND PRESSURE PLATE ASSEMBLY ONTO AN EXISTING ENGINE: Do...

I don’t think that was the issue, I was told the carb I had is too small CFM wise, the one put on my car is a 450 CFM and the one required for my...

HI there, It doesn't sound like an issue with the needle to jet interaction. It sounds more to me like there is an internal leak or the passage...

The car has the L-82 350 w/ manual 4 speed trans, yea since the carb was “rebuilt” I could never get it to idle correctly I would have to hold the...

Which engine/transmission is in your car now? According to this site: http://corvettec3.ca/carb.htm The right carb, depending on which engine you...

HI there, Yes, the process should be in your service manual in section 7 If I am looking at the whole picture, mileage plays as a part in...

Hi Paul: Where would I find a copy of that process? Would it be in the service manual? While replacing the clutch assembly would you...

Thanks for the information I sold the car today so it’s out of my hands now Sent from my iPhone using Tapatalk

Unfortunately, I have seen new torque converters have this issue. I would say if my description of the noise going away at highway speeds or even...

I'd echo the DIY concept. Most of us love working on our cars, even if it's just basic maintenance. But, mid-engine cars have a history of being...

I had local shop rebuild the transmission and supply the new converter Sent from my iPhone using Tapatalk

A new torque converter was installed when I replaced the transmission Sent from my iPhone using Tapatalk

So it looks like you HAVE to get Z51 to get FE4 MSRC ? Strange.

Good info, thanks.

THANK YOU for sharing with our members. Allthebest, Paul

HI there, There is also a process in GM service information that lays it all out. Allthebest, Paul

HI there, Unfortunately, you have a bad torque converter stator one way clutch. When you are up at highway speeds, it will most likely lower...

Thank you very much for your reply. I thought that that should be a standard procedure but that not all technicians follow it. I will look for a...

Yes they should be installed in the same position on a new OEM flywheel. It should be standard procedure to do so, but it is not. When I had my...